Table of Contents
Advertisement
F110
Always ON Terminal Function
Program Terminal Input Terminals
This parameter selects the functionality of the virtual input terminal ON. As a
virtual terminal, the ON control terminal exists only in memory and is
considered to be always in its True (or connected to CC) state.
It is often practical to assign this terminal to a function that the user desires to
be maintained regardless of external conditions or operations.
This parameter sets the programmable ON terminal to one of the possible
functions that are listed in
Table 10 on pg.
Input Terminal 1 (F) Function
Program Terminal Input Terminals
This parameter selects the functionality of the F input terminal.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable F terminal to one of the possible
functions that are listed in
Table 10 on pg.
Input Terminal 2 (R) Function
Program Terminal Input Terminals
This parameter selects the functionality of the R input terminal.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable R terminal to one of the possible
functions that are listed in
Table 10 on pg.
Input Terminal 3 (ST) Function
Program Terminal Input Terminals
This parameter selects the functionality of the ST input terminal.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable ST terminal to one of the possible
functions that are listed in
Table 10 on pg.
Input Terminal 4 (RES) Function
Program Terminal Input Terminals
This parameter selects the functionality of the RES input terminal.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable RES terminal to one of the possible
functions that are listed in
Table 10 on pg.
82
182.
182.
182.
182.
182.
Direct Access Number — F110
Parameter Type — Selection List
Factory Default — No Function is
Assigned
Changeable During Run — No
Direct Access Number — F111
Parameter Type — Selection List
Factory Default — F: Forward Run
Command
Changeable During Run — No
Direct Access Number — F112
Parameter Type — Selection List
Factory Default — R: Reverse Run
Command
Changeable During Run — No
Direct Access Number — F113
Parameter Type — Selection List
Factory Default — ST: Standby
Changeable During Run — No
Direct Access Number — F114
Parameter Type — Selection List
Factory Default — RES: Reset
Changeable During Run — No
WX9 ASD Installation and Operation Manual
F114
Advertisement
Table of Contents
