Table of Contents
Advertisement
System Configuration and Menu Options
Root Menus
The MODE key accesses the three primary screens of the WX9 ASD — the
screen,
Monitor
through to the other two screens (see
the ESC key toggles the menu to and from the EOI Command menu and the Frequency Command
screen.
Note:
Parameter changes made from the EOI Command menu are effective for Hand EOI
control Only.
Figure 30. WX9 ASD Root Menu Mapping.
Frequency Command Screen
Frequency Setting
While operating in the Hand mode (Hand/Auto LED is illuminated), the running frequency of the
motor may be set from the
Frequency Command value and then press the RUN key. The motor will run at the Frequency
Command speed, which may be changed while running.
Alarm/Fault Screen
Alarms and Faults are displayed as they are incurred. During an active alarm, the display toggles to and
from the running frequency and the active alarm. During an active fault, the fault is displayed. Once the
cause of the trip has been corrected, performing a Reset clears the Fault screen. Once cleared, NERR is
displayed to indicate that there are no errors.
A listing of codes along with their associated causes and remedies is provided in the section titled
Alarms, Trips, and Troubleshooting on pg.
WX9 ASD Installation and Operation Manual
screen, and
Program Menu
Figure
Frequency Command
screen. From either screen, press the MODE key to loop
30). While on the Frequency Command screen, pressing
screen. Using the Rotary Encoder, enter the
187.
Frequency Command
43
Advertisement
Table of Contents
