Table of Contents
Advertisement
Figure 21. The WX9 ASD Electronic Operator Interface Features.
LED/LCD Display Unit
Remove the Phillips screw
first to remove the LED/
LCD
display
unit
activate the
Battery Backup
system.
LED Screen
LCD Screen
EOI Features
LED Screen
LCD Screen
voltage, torque, etc.), diagnostic information, and LED screen information in expanded normal text.
Rotary Encoder
parameter, and perform the Enter (select) function. Turn the Rotary Encoder either clockwise or
counterclockwise to perform the Up or Down functions of the displayed menu selection. Press the Rotary
Encoder to perform the Enter (select) function.
HAND/AUTO Key
when the system is in the Hand mode. The Hand mode allows the Command and Frequency control
functions to be carried out via the EOI.
The Auto mode enables the Command and Frequency control functions to be carried out via the
Terminal Board, RS485, Communication Card, or Pulse Input. The selection may be made via
Program Fundamental Standard Mode Selection
1, respectively.
ESC Key
— Returns the system to the previous level of the menu tree, toggles between the EOI
Command screen and the Frequency Command screen, or cancels changes made to a field if pressed
while still in the reverse video mode (dark background/light text). The three functions are menu-specific.
RUN Key
— Issues the Run command while in the Hand mode. The RUN key LED illuminates green
while stopped and red while running or exciting the motor.
MODE Key
the system through the root menus (see
Program menu will display the default Program root menu screen item or the Program sub-menu item
being accessed prior to pressing the MODE key.
STOP/RESET Key
1.
Issues the Off command (decelerates to Stop at the programmed rate) if pressed once.
2.
Initiates an Emergency Off command if pressed twice quickly. The Emergency Off function
terminates the WX9 ASD output and will apply the stopping method selected at F603.
3.
Resets active Faults and/or active Alarms if pressed twice quickly. The source of the Fault or
Alarm must be determined and corrected before normal ASD operation can resume.
32
to
— Displays the running frequency, active Fault, or active Alarm information.
— Displays configuration information, performance data (e.g., output frequency, bus
— Used to access the WX9 ASD menu selections, change the value of a displayed
— Toggles the system to and from the Hand and Auto modes. The LED is on
— Provides a means to access the root menus. Pressing the MODE key repeatedly loops
— This key has three functions.
Command Mode Selection
Figure 30 on pg.
43). While looping through the root menus, the
Rotary Encoder
HAND/AUTO Key (LED)
ESC Key
RUN Key (LED)
MODE Key
STOP/RESET Key
and
Frequency Mode
WX9 ASD Installation and Operation Manual
Advertisement
Table of Contents
