Toshiba WX9 ASD Installation & Operation Manual page 180

F675
MON 2 Terminal Meter Adjustment
Program Terminal Analog Output Terminals
This parameter is used to set the gain of the MON2 output terminal and is used
in conjunction with the settings of MON2 Terminal Meter Selection (F674).
See MON2 Terminal Meter Selection (F674) for additional information on
this setting.
Pulse Output Function
Program Terminal FP Terminal Settings
This parameter commands the multifunction programmable FP terminal to
monitor the value of 1 of 31 possible system functions.
As the assigned function changes in magnitude or frequency, the pulse count of
the FP output pulse train changes in direct proportion to changes in the
assigned function.
Note: The duty cycle of the output pulse train remains at 65 ±5.0 µS.
Possible assignments for this output terminal are listed in
Pulse Output Frequency
Program Terminal FP Terminal Settings
This parameter sets the full-scale reading of the FP Terminal. The full-scale
reading of the monitored variable selected at Pulse Output Function (F676)
may be set here.
Optional Analog Terminal Mark
Program Special Special Parameters
This parameter sets the full-scale reading of the FP Terminal. The full-scale
reading of the monitored variable selected at Pulse Output Function (F676)
may be set here.
Current/Voltage Units Setup
Program Utilities Display Parameters
This parameter sets the unit of measurement for current and voltage values
displayed on the EOI.
Settings:
0 — %
1 — A/V
168
Direct Access Number — F675
Parameter Type — Numerical
Factory Default — 512
Changeable During Run — Yes
Minimum — 1
Maximum — 1280
Direct Access Number — F676
Parameter Type — Selection List
Factory Default — Output Frequency
Changeable During Run — Yes
Table 11 on pg. 186.
Direct Access Number — F677
Parameter Type — Numerical
Factory Default — 3840
Changeable During Run — Yes
Minimum — 1000
Maximum — 43200
Units — kHz
Direct Access Number — F680
Parameter Type — Numerical
Factory Default — 0
Changeable During Run — Yes
Minimum — 0
Maximum — 3
Direct Access Number — F701
Parameter Type — Selection List
Factory Default — %
Changeable During Run — Yes
WX9 ASD Installation and Operation Manual
F701