Table of Contents
Advertisement
F805
Send Waiting Time (TTL)
Program Communications Communication Settings
This parameter sets the TTL response delay time.
Note:
Changes made to this parameter require that the power be cycled
(off then on) for the changes to take effect.
ASD to ASD Communication (TTL)
Program Communications Communication Settings
In a master/follower configuration, this setting determines the output parameter
of the master ASD that will be used to control the applicable follower ASDs.
Note:
Select No Follower if ASD to ASD Communication (RS232/
RS485)
F826
is configured as a Master Output controller.
Otherwise, an EOI failure will result.
Note:
Changes made to this parameter require that the power be cycled
(off then on) for the changes to take effect.
Settings:
0 — Normal (No Follower)
1 — Frequency Command
2 — Output Command Frequency
3 — Torque Command
4 — Output Torque Command
Frequency Point Selection
Program Communications Communication Adjustments
This parameter selects the communications reference for scaling.
See
F811
—
F814
for additional information on this setting.
Note:
Scaling the communications signal is not required for all
applications.
Note:
Changes made to this parameter require that the power be cycled
(off then on) for the changes to take effect.
Settings:
0 — Disabled
1 — Common Serial (TTL)
2 — RS232/RS485
3 — Communication Option
WX9 ASD Installation and Operation Manual
Direct Access Number — F805
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 2.00
Units — Seconds
Direct Access Number — F806
Parameter Type — Selection List
Factory Default — Normal (No
Follower)
Changeable During Run — Yes
Direct Access Number — F810
Parameter Type — Selection List
Factory Default — Disabled
Changeable During Run — Yes
F810
173
Advertisement
Table of Contents
