Table of Contents
Advertisement
ASD OL (Overload) Trip — Displays the ASD Overload as a percentage of the rated capacity
of the WX9 ASD.
DBR OL (Overload) Trip (not used) — Displays the DBR Overload value as a percentage of the
Dynamic Braking Resistor capacity.
Motor Load — Displays the Motor Load in real-time as a percentage of the rated capacity of the
motor.
ASD Load — Displays the ASD Load as a percentage of the rated capacity of the WX9 ASD.
DBR Load (not used) — Displays the DBR Load as a percentage of the Dynamic Braking
Resistor capacity.
Input Power — Displays the Input Power in Kilowatts (Kw).
Output Power — Displays the Output Power in Kilowatts (Kw).
Peak Current — Displays the Peak Current since the last start was initiated. The current is
displayed as a percentage of the rated capacity of the WX9 ASD.
Peak Voltage — Displays the Peak Voltage since the last start was initiated. The voltage is
displayed as a percentage of the rated capacity of the WX9 ASD.
PG Speed — Displays the PG Speed.
Direction — Displays the Direction command (forward/reverse).
PG Position — Displays the Pulse Generator Position.
RR — Displays the RR input value as a percentage of the full range of the RR value (potentiometer
input).
*VI/II — Displays the VI/II signal level as a percentage of the full range of the VI/II value.
Note: * The VI/II input represents two analog inputs (and terminals). The VI input terminal
is used for a 0 – 10 VDC analog signal and the II input terminal is used for current
loop applications, such as with a 4-20 mA signal. Either may be used as a frequency
or torque command source; however, the two cannot function simultaneously.
Throughout this manual, they will be listed as VI/II. See
on the setup of this terminal.
RX — Displays the RX input setting as a percentage of the full range of the RX value (-10 to
+10 VDC input).
RX2 — Displays the RX2 input setting as a percentage of the full range of the RX2 value.
Note: The RX2 function is available on the Expansion IO Card Option 1 option board
(P/N ETB003Z) only.
FM Output — Displays the output frequency value as a percentage of the full range of the FM
value.
AM Output — Displays the output current as a percentage of the full range of the AM value.
Max. Output — Not Used.
Pattern Select — Displays the selected pattern when using the Pattern Run function.
Repeats Left — Displays the number of remaining patterns when using the Pattern Run function.
Pattern — Displays the active Pattern Run ID number when using the Pattern Run function.
Pattern Time Left — Displays the remaining time for the active Pattern Run Group.
46
F201
for more information
WX9 ASD Installation and Operation Manual
Advertisement
Table of Contents
