Eoi Command (Rs232/Rs485) Menu - Toshiba WX9 ASD Installation & Operation Manual

EOI Command (RS232/RS485) Menu

The Command (RS232/RS485) menu is accessed by pressing ESC from the
screen. The control settings of the Command (RS232/RS485) menu are effective for EOI control only.
The Command (RS232/RS485) menu provides quick access to the following menu parameters:
Direction — Forward or Reverse.
Stop Pattern — The Decel Stop or Coast Stop selection determines the method used to stop the
motor when using the STOP/RESET key of the EOI. The Decel Stop setting enables the DC
Injection Braking system setup at F250, F251, and F252. The Coast Stop setting allows the motor to
stop at the rate allowed by the inertia of the load.
Note: The Stop Pattern setting has no effect on the Emergency Off settings of F603.
V/f Group — One of four V/f profiles may be selected and run. Each V/f profile is comprised of four
user settings: Base Frequency, Base Frequency Voltage, Manual Torque Boost, and Motor
Overload Protection. Expanded descriptions of these parameters may be found in the section titled
Direct Access Parameter Information on pg. 69
Acc/Dec Group — One of four Acc/Dec profiles may be selected and run. Each of the Acc/Dec
profiles is comprised of three user settings: Acceleration, Deceleration, and Pattern. Expanded
descriptions of these parameters may be found in the section titled
Information on pg. 69
PID Control — This feature enables or disables the PID feedback function.
Torque Limit Group — This parameter is used to select one of four preset positive torque limits to
apply to the active motor (of a multiple motor configuration). The settings of profiles 1 – 4 may be
setup at F441, F444, F446, and F448, respectively.
44
(see F504).
(see V/f Switching Profile).
Direct Access Parameter
WX9 ASD Installation and Operation Manual
Frequency Command