Table of Contents
Advertisement
F503
S-Curve Acceleration/Deceleration Pattern 2
Program Special Acc/Dec (1 - 4) Settings
This parameter enables a user-selected preprogrammed output profile that
controls the acceleration and deceleration pattern for the Acceleration/
Deceleration (Acc/Dec) 2 parameter.
Settings:
0 — Linear
1 — S-Pattern 1
2 — S-Pattern 2
152
Direct Access Number — F503
Parameter Type — Selection List
Factory Default — Linear
Changeable During Run — Yes
WX9 ASD Installation and Operation Manual
F503
Advertisement
Table of Contents
