Table of Contents
Advertisement
F133
Output Terminal 4 (OUT3) Function
Program Terminal Output Terminals
This parameter sets the functionality of the OUT4 terminals to any of the
possible functions that are listed in
The on and off delay times of the OUT4 terminals may be adjusted to provide
more response time to the device that is connected to the output terminals.
In addition, the output terminals must be specified as Normally Open or
Normally Closed.
Note:
The Expansion IO Card Option 1 option board (P/N ETB003Z)
is required to use this terminal.
See the Expansion IO Card Option 1 instruction manual (P/N 58685) for
additional information on the function of this terminal.
Output Terminal 5 (OUT4) Function
Program Terminal Output Terminals
This parameter sets the functionality of the OUT5 terminals to any of the
possible functions that are listed in
The on and off delay times of the OUT5 terminals may be adjusted to provide
more response time to the device that is connected to the output terminals.
In addition, the output terminals must be specified as Normally Open or
Normally Closed.
Note:
The Expansion IO Card Option 1 option board (P/N ETB003Z)
is required to use this terminal.
See the Expansion IO Card Option 1 instruction manual (P/N 58685) for
additional information on the function of this terminal.
Output Terminal 6 (R1) Function
Program Terminal Output Terminals
This parameter sets the functionality of the OUT6 terminals to any of the
possible functions that are listed in
The on and off delay times of the OUT6 terminals may be adjusted to provide
more response time to the device that is connected to the output terminals.
In addition, the output terminals must be specified as Normally Open or
Normally Closed.
Note:
The Expansion IO Card Option 1 option board (P/N ETB003Z)
is required to use this terminal.
See the Expansion IO Card Option 1 instruction manual (P/N 58685) for
additional information on the function of this terminal.
WX9 ASD Installation and Operation Manual
Table 11 on pg.
186.
Table 11 on pg.
186.
Table 11 on pg.
186.
Direct Access Number — F133
Parameter Type — Selection List
Factory Default — LL: Lower-Limit
Frequency
Changeable During Run — No
Direct Access Number — F134
Parameter Type — Selection List
Factory Default — UL: Upper-Limit
Frequency
Changeable During Run — No
Direct Access Number — F135
Parameter Type — Selection List
Factory Default — RCH: Speed Reach
Signal
Changeable During Run — No
F135
87
Advertisement
Table of Contents
