Toshiba WX9 ASD Installation & Operation Manual page 166

F505
Acceleration/Deceleration Switching Frequency 1
Program Special  Acc/Dec Special
This parameter sets the frequency at which the acceleration control is switched
from the Acceleration (Acc) 1 Profile to the Acceleration (Acc) 2 Profile
during a multiple-profile configuration.
S-Pattern Acceleration Lower-Limit Adjustment
Program Special Acc/Dec Special
During an S-Pattern 1 or 2 sequence, this parameter settings modifies the
acceleration rate for the lower part of the acceleration curve by the percentage
set here.
This function is commonly used with transportation and lifting applications.
See S-Curve Acc/Dec Pattern 1 (F502) and Acc/Dec Pattern 1-4 Selection
(F504) for additional information on this setting.
S-Pattern Acceleration Upper-Limit Adjustment
Program Special Acc/Dec Special
During an S-Pattern 1 or 2 sequence, this parameter setting modifies the
acceleration rate for the upper part of the acceleration curve by the percentage
set here.
This function is commonly used with transportation and lifting applications.
See S-Curve Acc/Dec Pattern 1 (F502) and Acc/Dec Pattern 1-4 Selection
(F504) for additional information on this setting.
Acceleration/Deceleration Time Lower Limit
Program Special Acc/Dec Special
This parameter sets the lower-limit of the Acceleration/Deceleration (Acc/
Dec) time.
See Acc/Dec Pattern 1-4 Selection (F504) for additional information on this
setting.
Acceleration Time 3
Program Special  Acc/Dec (1 - 4) Settings
This parameter specifies the time for the drive to go from 0.0 Hz to the
Maximum Frequency for the Acceleration (Acc) 3 Profile.
The Acceleration/Deceleration (Acc/Dec) pattern may be set using F502.
The minimum Acceleration/Deceleration (Acc/Dec) time may be set using
F508.
Note: An acceleration time that is shorter than the load will allow may
cause nuisance tripping and mechanical stress to loads.
Automatic Acceleration/Deceleration, Stall, and Ridethrough
settings may lengthen the acceleration time.
154
Direct Access Number — F505
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — Maximum Freq. (F011)
Units — Hz
Direct Access Number — F506
Parameter Type — Numerical
Factory Default — 25.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 50.00
Units — %
Direct Access Number — F507
Parameter Type — Numerical
Factory Default — 25.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 50.00
Units — %
Direct Access Number — F508
Parameter Type — Numerical
Factory Default — 0.10
Changeable During Run — Yes
Minimum — 0.01
Maximum — 10.00
Units — Seconds
Direct Access Number — F510
Parameter Type — Numerical
Factory Default — (ASD-Dependent)
Changeable During Run — Yes
Minimum —
Maximum — 6000
Units — Seconds

WX9 ASD Installation and Operation Manual
F510
F508