Table of Contents
Advertisement
WX9 ASD Control
The Control Board (P/N 56000) serves as the primary control source for the WX9 ASD and receives
input from the Terminal Board (see
Communications, or the EOI.
The Control Board has been enhanced to support two additional functions: Multiple Protocol
Communications and the ability to communicate in either half- or full-duplex modes.
Using the optional multiple-protocol communications interface (the ASD-NANOCOM), the Control
Board may be configured for the type of communications protocol being received and respond
appropriately to the sending device. The ASD-NANOCOM connects to the J4 and J5 connectors
(see
Figure
6.). Jumper Board (P/N 55365) is required at the J4 connector if not using the ASD-
NANOCOM.
The ASD-NANOCOM must be setup to support the desired communications protocol via Program
Communication Communication Settings. Consult the ASD-NANOCOM User Manual
(P/N 10572-1.000-000) for a complete listing of the setup requirements.
Half- or full-duplex communications is available when using RS232/RS485 communications. The
jumpers at the JP1 and the JP2 connectors may be moved from one position to the other to facilitate
either half- or full-duplex operation. If no jumpers are used, the system will operate in the full-duplex
mode.
Figure 8. JP1 and JP2 Half/Full-Duplex Jumper Settings.
For more information on the WX9 ASD communication requirements, please visit
www.tic.toshiba.com/ind/ to acquire a copy of the 7-Series Communications User Manual and visit
www.iccdesigns.com to acquire a copy of the ASD-NANOCOM User Manual. Contact the TIC
Customer Support Center if more information is required on the ASD-NANOCOM.
Figure 9. Control Board of the WX9 ASD.
CN8
Sink/Source
Switching
CNU2
(EOI connection
and TTL I/O)
CN3
(RS232/RS485
signal I/O)
CNU1
(RS232/RS485
signal I/O)
CNU4
JP1/JP2 Jumpers
(Half-/Full-Duplex
Selection)
WX9 ASD Installation and Operation Manual
Figure 6. on pg.
21), an
CNU3
J4
J5
ASD-NANOCOM
Option
Card, RS232/RS485
CN7
25-pin D-type connector.
(Connects to the Terminal
Board .)
CN2
25
Advertisement
Table of Contents
