Table of Contents
Advertisement
F260
Jog Frequency
Program Frequency Jog Settings
This parameter sets the output frequency of the drive during a Jog. Jogging is
the term used to describe turning the motor on for small increments of time and
is used when precise positioning of motor-driven equipment is required.
The Jog function may be initiated from the EOI , remotely via the Terminal
Board, or using Communications (for additional information on using
Communications for Jogging, see the Communications manual).
To perform a Jog, set this parameter to the desired Jog frequency.
Select a Jog Stop method (F261).
Jog Using the Terminal Board
To initiate a Jog from the Control Terminal Strip, perform the following:
1.
Assign a discrete input terminal to the Jog function (see
pg.
182).
2.
Assign a discrete input terminal to the F (Forward) function (and
Reverse if required) (see
3.
Provide a Forward and/or Reverse command from the Terminal
Board.
4.
Place the system in the Auto mode (Hand/Auto LED is off).
5.
Connect the assigned Jog terminal (from step 1) to CC for the desired
Jog duration.
The system will run at the
F260
and will stop using the Jog Stop Pattern
deactivation.
Jog Stop Pattern
Program Frequency Jog Settings
This parameter sets the stopping method used while operating in the Jog mode.
Note:
This parameter setting is used for the Jog operation only. The
Emergency Off stopping method setting of
over this setting and changes made here do not affect the
function or setting of F603.
Settings:
0 — Deceleration
1 — Coast
2 — DC Injection
116
Table 10 on pg.
182).
speed for the duration of the terminal activation
(F261)
method upon terminal
F603
has priority
Direct Access Number — F260
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 20.00
Units — Hz
Table 10 on
Direct Access Number — F261
Parameter Type — Selection List
Factory Default — Deceleration
Changeable During Run — Yes
WX9 ASD Installation and Operation Manual
F261
Advertisement
Table of Contents
