Table of Contents
Advertisement
7. Command Source
This selection establishes the source of the Run commands (e.g., F, R, Stop, etc.).
Settings:
0 — Terminal Board
1 — CN8 Option (LED Keypad)
2 — TTL
3 — RS232/RS485
4 — Communication Card
8. Frequency Command Source
This selection establishes the source of the Frequency (speed) command.
Settings:
1 — VI/II
2 — RR
3 — RX
4 — RX2 (option)
5 — CN8 Option (LED Keypad)
6 — Binary/BCD Input
7 — TTL
8 — RS232/RS485
9 — Communication Card
10 — UP/DOWN Frequency
11 — Pulse Input (option)
9. Wizard Finished!
This screen is the final screen of the Startup Wizard.
The basic parameters of the WX9 ASD have been set.
Click Exit to load the Startup Wizard input and to
return to the Frequency Command screen. Additional
application-specific programming may be required.
68
WX9 ASD Installation and Operation Manual
Advertisement
Table of Contents
