Table of Contents
Advertisement
Equipment Warning Labels
DO NOT attempt to install, operate, perform maintenance, or dispose of this equipment until you have
read and understood all of the product labels and user directions that are contained in this manual.
Warning labels that are attached to the equipment will include the exclamation mark within a triangle.
DO NOT remove or cover any of these labels. If the labels are damaged or if additional labels are
required, contact the TIC Customer Support Center.
Labels attached to the equipment exist to provide useful information or to indicate an imminently
hazardous situation that may result in serious injury, severe property and equipment damage, or loss of
life if safe procedures or methods are not followed as outlined in this manual.
Qualified Personnel
Installation, operation, and maintenance shall be performed by Qualified Personnel ONLY. A
Qualified Person is one who has the skills and knowledge relating to the construction, installation,
operation, and maintenance of the electrical equipment and who has received safety training on the
hazards involved (refer to the latest edition of the NFPA 70E for additional safety requirements).
Qualified Personnel shall:
•
Have carefully read the entire manual.
•
Be familiar with the construction and function of the ASD, the equipment being driven, and the
hazards involved.
•
Be able to recognize and properly address hazards associated with the application of motor-driven
equipment.
•
Be trained and authorized to safely energize, de-energize, ground, lock-out/tag-out circuits and
equipment, and clear faults in accordance with established safety practices.
•
Be trained in the proper care and use of protective equipment such as safety shoes, rubber gloves,
hard hats, safety glasses, face shields, flash clothing, etc., in accordance with established safety
practices.
For additional information on workplace safety, visit www.osha.gov.
Equipment Inspection
•
Upon receipt of the equipment, inspect the packaging and equipment for shipping damage.
•
Carefully unpack the equipment and check for missing parts, parts that may have been damaged
during shipping, and any concealed damage. If any discrepancies are discovered, it should be noted
with the carrier prior to accepting the shipment, if possible. File a claim with the carrier if necessary
and immediately notify the TIC Customer Support Center.
•
DO NOT install the ASD if it is damaged or missing any component(s).
•
Ensure that the rated capacity and the model number specified on the nameplate conform to the
order specifications.
•
Modification of this equipment is dangerous and is to be performed by factory-trained personnel
ONLY. When modifications are required, contact the TIC Customer Support Center.
•
Inspections may be required after moving the equipment.
•
Contact the TIC Customer Support Center to report discrepancies or receive assistance if required.
2
WX9 ASD Installation and Operation Manual
Advertisement
Table of Contents
