Table of Contents

Advertisement

Alarms

An Alarm is an indication that a Fault is imminent if existing operating conditions continue unchanged.
Table 13
lists the alarm codes that may be displayed during operation of the WX9 ASD. Each alarm code
listed is accompanied by a description and a possible cause. In the event that the source of the malfunction
cannot be determined, contact the TIC Customer Support Center for more information on the condition
and an appropriate course of action.
During an active Alarm, the display toggles to and from the running frequency and the active Alarm. In
the case of multiple Alarms, only the first to be detected will be displayed on the Frequency Command
screen.
Note:
Some User Notification conditions and Alarms may be annunciated via a discrete
output terminal setting. See
conditions that may be associated with an output terminal.
LED Display
LCD Display
Internal communications
CM1
Comm1 Error
error.
External communications
CM2
Comm2 Error
error.
Active ground fault.
EF
Earth Fault
Incorrect current reading
EFU
DC Fuse Open
at DC fuse circuit.
Incorrect setup at an
Err1
Point Setting Error
analog input (e.g., VI/II,
RR, etc.).
LOD function enabled and
LOD
PID Low Output
the output frequency is
Disable
less than the
Under-voltage condition at
MOFF
Main Under-
the three-phase AC input
Voltage
to the ASD.
WX9 ASD Installation and Operation Manual
Table 12 on pg. 188
Table 13. WX9 ASD Alarms.
Description
• Improperly programmed ASD.
• Improper communications settings.
• Improperly connected cables.
• Ground fault at the motor.
• Ground fault at the output of the ASD.
• Current leakage to Earth Ground.
• Open circuit at DC bus circuit.
• Gain and bias settings for an analog input are either the same
• Disable the LOD function at
F732
setting.
• Low commercial input voltage.
for a listing of the possible system
Possible Causes/Troubleshooting
or too close to each other (e.g.,
Output Disable Start Level at F732.
F201
and
F203
are equal).
F731
or increase the Low
189

Advertisement

Table of Contents
loading

Table of Contents