Advertisement
Printing Directly From a Mainframe Computer with LCDS
file:///C|/Documents%20and%20Settings/Miz%20B/My%2...TA/Nuvera%209.0%20UGTA_FINAL/English/hdi_p_037.htm (2 of 2)8/13/2008 2:19:40 PM
7. To select the specific types of resources displayed in the LCDS Resources window, click the Types... button which opens the
System Resource Types dialog. After selecting the desired resource types (by marking the checkboxes), click OK.
Related Hints and Tips
Subtopic
Offset recovery
Offset Recovery is not supported when a DFA device is attached. There will be no offset on the output to indicate
where the fault had occurred. It will only work when there is a BFM or MFF attached.
Offset with DFA
Only offset by job boundary or set boundary is supported with the third party inline DFA finishing devices. DFA
devices do not support single page offsetting specified within the LCDS job or report. A single page job or report
will be offset.
Related Information
For further information about LCDS printing with the system, and for queue setup information, refer to the LCDS Print documentation that
is provided along with the LCDS license software CD. See your System Administrator or Xerox Customer Representative to obtain this
documentation.
Hint/Tip Description
86 of 256
Advertisement
