Advertisement
|
Home
How Do I?
file:///C|/Documents%20and%20Settings/Miz%20B/My%20D...0UGTA/Nuvera%209.0%20UGTA_FINAL/English/psg_iq20.htm8/13/2008 2:37:10 PM
|
Resources
|
System Tour
Removing Lines, Streaks or Shadows
(when copying or scanning)
This problem can usually be attributed to a poor original, or a dirty scanner. Try one or a combination of the following to correct the
problems.
To remove lines, streaks or shadows
Clean the Document Glass, especially near the white plastic ramp on the left edge of the glass, if using the Document Feeder
Run the job from the Document Glass
Check the quality of the original. Use Border Erase or Edge Erase to remove lines from the edges of the document
Turn on Background Suppression
Load fresh paper
TIP: If you have programmed and run a job, and received unexpected results, ensure that the system-wide settings are all set
back to their defaults by clicking <Clear All> or <Reset> in the user interface. Then proceed to do job programming pertinent
to your job.
If the problem continues, you may want to run the Corotron Cleaning Routine under User Diagnostics. See your Xerox Representative
for advice.
|
Search
|
Problem Solving
248 of 256
|
Index
About this Site
|
Maintenance
Advertisement
