Advertisement
|
Home
How Do I?
file:///C|/Documents%20and%20Settings/Miz%20B/My%2...uvera%209.0%20UGTA_FINAL/English/spec_paper_60.htm (1 of 2)8/13/2008 5:01:07 PM
|
Resources
|
System Tour
Paper Through Document Feeder Performance Matrix
The Xerox Nuvera can process a wide array of stock types. Use the following topics to learn how each stock type can be expected to
perform in the system.
TIP: If you're having feeding problems through the Document Feeder, all problems can be avoided by scanning directly from the
Document Glass.
Types and Conditions of Originals
12 x 18 inch originals
Coated paper
High Talc paper
Originals produced on a DocuTech 100/120
Originals produced on a DocuTech 100/120
Xerographic color originals
Originals consisting of mostly pencil marks
Dog-eared originals (folded corners)
Too many sheets in the stack
Folded originals
Originals with sticky-notes attached
Envelopes
Tab stock
Labels
GBC-brand papers
Glossy photographs
Transparencies
Table Legend
SEF: Short Edge Feed
LEF: Long Edge Feed
Best: Best system performance
|
Search
|
Problem Solving
Rating Notes
A 12x18 inch original actually will travel through the Document Feeder,
Do Not
but there is a good chance some information on the output will be lost. To
Feed
ensure all image information from a 12 x 18 inch original is captured, use
the Document Glass.
Feeding lightweight coated originals (approximately 16 lb. or 61 gsm) will
normally work fine. You may experience problems with the alignment of
Fair
the copy images if a color image is within 0.4 inches of the leading edge
(the side of the document fed first) of the original.
Good /
Originals with a high talc content may contaminate the Document Feeder
Fair
Feed Rolls, resulting in degraded performance.
On copies with a high-area coverage (pictures and halftones) tends to rub
Fair
off on Feed Rolls, causing feeding faults.
Good /
Oils used to fuse the copies need to dry at least 2 hours in order to
Fair
prevent feeding problems.
Do Not
Use Document Glass to avoid feeding problems.
Feed
Will transfer lead to the Feed Rolls, causing the originals to smear.
Do Not
Originals with occasional marks (i.e., a document with review markup)
Feed
should feed satisfactorily. To avoid problems, feed all pencil-marked
originals from the Document Glass.
Do Not
Originals with dog-ears or folded corners on the lead edge may cause a
Feed
jam. Ensure that the folds are removed.
Depending on the model, the Document Feeder can feed up to 300
sheets of 20 lb. paper. The quantity that can be fed decreases as paper
Do Not
weight increases.
Feed
Use Build Job to feed more than these amounts as a single copy job.
Do Not
Folded originals do not trigger the automatic sensors in the Document
Feed
Feeder. Ensure that the folds are removed.
Do Not
May be fed after sticky notes removed.
Feed
Do Not
Copy from the Document Glass.
Feed
Do Not
Copy from the Document Glass.
Feed
Do Not
Copy from the Document Glass.
Feed
Do Not
Copy from the Document Glass.
Feed
Do Not
Copy from the Document Glass.
Feed
Do Not
Copy from the Document Glass.
Feed
202 of 256
|
Index
About this Site
|
Maintenance
Advertisement
