Advertisement
|
Home
How Do I?
file:///C|/Documents%20and%20Settings/Miz%20B/My%20D...0UGTA/Nuvera%209.0%20UGTA_FINAL/English/psg_iq90.htm8/13/2008 2:37:23 PM
|
Resources
|
System Tour
Removing Drill Holes From Output
(when scanning or copying)
If you are scanning or copying originals that have been drilled for insertion in a multi-ring binder, or the paper is otherwise damaged at
the edge, you may notice black holes or other unacceptable marks on one edge of your output image. Electronic Hole Removal can be
enabled to eliminate such defects.
TIP: The Electronic Hole Removal feature is also useful for removing output image defects caused by folded-over corners (dog-
ears) and/or torn edges located within approximately one inch from the edge of the original document.
NOTE: Electronic Hole Removal is only functional for originals placed in the Document Feeder. For details, see
Document
Feeder.
NOTE: Electronic Hole Removal is NOT available when Photo is the Original Type selected.
To remove drill holes from output
1. Place original documents in the Document Feeder.
2. Make sure Electronic Hole Removal is enabled.
1. Click the Copy button.
2. Select the Image Edit tab.
3. Click the Edge Erase button.
4. Select Electronic Hole Removal. It should have a checkmark in it. If it does not, select [None] from the Edge Erase
list. This will enable the Electronic Hole Removal control.
3. When you are satisfied with your settings, click <Copy>.
|
Search
|
Problem Solving
256 of 256
|
Index
About this Site
|
Maintenance
Using the
Advertisement
