Advertisement
|
Home
file:///C|/Documents%20and%20Settings/Miz%20B/My%...GTA/Nuvera%209.0%20UGTA_FINAL/English/spec_40.htm (1 of 4)8/13/2008 4:44:15 PM
|
Resources
|
System Tour
Multifunction Finisher (MFF) Specifications
The Multifunction Finisher offers the basic publishing option on the Xerox Nuvera EA Production System. It is the only finisher in the
configuration and can not be followed by any other finishing devices. It provides stacking and stapling capabilities as well as the ability
to make booklets and trifold documents.
There are two MFF models available.
The Professional is a finisher that provides high capacity collating, stacking and stapling. It also allows the ability to make
booklets and trifold documents. This model consists of a Top Tray for collecting or purging sheets, a Main Tray and a Bottom
(Booklet) Tray.
The Pro Plus is the Professional model with added functionality provided in the Interface Module area. The Interface Module
contains a sheet insertion module as well as a hole punch module. The post process insertion capability of the MFF Pro Plus
can insert covers, preprinted tabs and colored paper. The hole punch module offers either a 2 and 3 Hole Paper Punch or a 2
and 4 Hole Paper Punch that allows you to punch 2, 3 or 4 holes in the printed document, depending on the paper punch
installed and the finishing hole punch option selected.
Using the MFF
Go to
Using the Multifunction Finisher Module
Specifications
250 sheets of 20 lb bond (75 gsm) or equivalent
Output to the Top Tray is delivered with Side-1 down and sets are not
offset. It can be set as a destination tray for non-stapled jobs. Sheets less
Top Tray
than 7 inches in the process direction or 8 inches in the cross-process
direction will automatically go to the Top Tray. The Top Tray also
receives sheets that are purged from the system.
250 sheets of 20 lb bond (75 gsm) or equivalent
Output to the Top Tray is delivered with Side-1 down and sets are not
offset. It can be set as a destination tray for non-stapled jobs. Sheets less
Bottom/Booklet Tray
than 7 inches in the process direction or 8 inches in the cross-process
direction will automatically go to the Top Tray. The Top Tray also
receives sheets that are purged from the system.
Insertion Tray
Not available
3000 sheets of 20 lb bond (75 gsm) or equivalent
The stack limit can be set from the UI for each BFM independently.
Stapled sets with <15 sheets are limited to 100 sets.
Main Tray/Stacker Capacity
The Stacker is the output tray for receiving compiled stapled and
unstapled sets as well as single sheets. Output is normally delivered with
side-1 down and sets can be offset.
|
Search
|
Problem Solving
for information on how to use the MFF.
MFF Professional
174 of 256
|
Index
About this Site
|
Maintenance
MFF Pro Plus
Same
Does not accept hole
punched finishing
output
200 sheets of 20 lb
bond (75 gsm) or
equivalent
56-220 gsm
Delivers output to all
3 trays
Same
Advertisement
