Advertisement
|
Home
file:///C|/Documents%20and%20Settings/Miz%20B/My%20D...UGTA/Nuvera%209.0%20UGTA_FINAL/English/comp_070a.htm8/13/2008 1:45:40 PM
|
Resources
|
System Tour
Using the Feed Module Tab Guides
Use the Feed Module Tab Guides to improve the feeding of tab stock from any tray in the Feed Module.
NOTE: Do not use tab stock unless you install the appropriate Tab Guide in the paper tray where the tab stock is
loaded.
There are two Tab Guides:
The A4/11" Tab Guide
The A5/5.5" Tab Guide
Both of the Tab Guides are mounted on brackets or in a molded pocket located inside the Feed Module Front Door.
Installing the Feed Module Tab Guides
1. Program your job as you normally would, including programming of Tabs stock as either the main body of the job or as special
pages or inserts.
2. Open the tray and remove the paper stock, if required. Move the paper guides to the open position in order to accommodate
the size of the tab stock.
3. Load the tabs into the tray. The label on the tray illustrates how to load the tab stock.
4. Adjust the paper tray guides. Ensure that the entire stack of tabs is positioned correctly in the tray.
5. Adjust any tabs that are misaligned.
6. Ensure that standard, uncoated tab stock is loaded a minimum ½ inch (12.7 mm) below the MAX line.
step. Approximately 100 laminated or coated tabs may be loaded at one time; this amount is significantly less than standard,
non-coated tabs. If a misfeed occurs while using laminated or coated tabs, remove some of the tabs from the tray.
7. Open the Feed Module Front Door. Remove the appropriate Tab Guide (A4/11" or A5/5.5") from the Feed Module bracket or
the molded pocket on the front door.
8. Install the appropriate Tab Guide (A4/11" or A5/5.5"). Align the Tab Guide with the Paper Tray Guide.
step.
9. Ensure that the Tab Guide is positioned underneath the actuator arm of the Paper Tray Guide.
Removing the Feed Module Tab Guides
1. Lift the Tab Guide until it touches the bottom side of the actuator arm.
2. Rotate the Tab Guide toward the tab stock to disengage the guide from the actuator arm.
3. Push the Tab Guide forward until the actuator arm is clear of the Tab Guide.
4. Remove the Tab Guide.
5. Place the Tab Guide into the bracket or molded pocket on the front door. Ensure that the Tab Guide is positioned behind the
hook.
Click here to view this step.
6. Close the front door.
More on printing with tabbed stock and other special papers
For more information, see
Loading Special Stock For Proper Finishing
|
Search
|
Problem Solving
Click here to view this step.
Click here to view this
step.
Click here to view this
step.
132 of 256
|
Index
|
Maintenance
Click here to view this
Click here to view this
step.
Click here to view this step.
Click here to view this step.
Output.
About this Site
Click here to view this
step.
Click here to view this
Click here to view this
step.
Advertisement
