Advertisement
Using Tabbed Stock
file:///C|/Documents%20and%20Settings/Miz%20B/My%20Documents/A_Xerox...P/Nuvera%209.0%20UGTA/Nuvera%209.0%20UGTA_FINAL/English/comp_070.htm (2 of 5)8/13/2008 1:45:49 PM
If printing on 8.5x11" tabs, set the properties for the tabs as single-sided Exception Pages and set image shift to 1/2".
If using preprinted tabs, add as Inserts.
If the job uses hole-punched tabs and hole-punched body stock, make sure the both stocks are loaded in the tray with the hole-punched
edge leading.
The system assumes tabs are right-edge portrait or bottom-edge landscape. If the job is different you may need to select [rotate 180] for the
entire job.
If using Build Job to program the tabs job, select Build Job Type: Contains Tab Stock or Envelopes.
Tabs can be loaded in the Insertion Module.
NOTE: If you are printing a job with preprinted tabs, program the job using Exception Pages/inserts. For more information on printing with
preprinted tabs, refer to
Adding Pages to your
refer to
Multifunction Finisher Specifications.
For the Xerox Nuvera® 288 Perfecting System - Using Media Optimization mode for tabs
You can print jobs that contain a mix of sizes and media, including full-cut and pre-cut tabbed stock. If you need to print a job containing 8.5 x 11 inch
paper, for example, containing 9 x 11 inch or A4 pre-cut tabs to be imaged, you must first enable the Pre-Cut Tabs selection from the Media
Optimization mode in the user interface. This provides you with the best throughput and productivity rate when printing with tabbed stock.
Use Media Optimization mode to increase your job's productivity rate otherwise affected by printing the tab portion of a duplex job, especially pre-cut
tabs.
If you are running a job that does not contain tabs, select Normal Mode from the Media Optimization Switches for the best throughput rate.
If you are printing on any size pre-cut tabbed stock, or printing on full-cut tabbed stock greater than 8.5 inches (215.9 mm) in the process
direction, select Pre-Cut Tabs from the Media Optimization Switches window.
The maximum throughput rate when the Media Optimization Switch is set to Pre-Cut Tabs is 240 ipm, regardless of whether the job
contains tabbed stock. Therefore, make sure the Media Optimization Switch is set to Normal Mode when printing jobs without cut tabs
To enable Media Optimization mode when printing with tabs to be imaged:
1. Load paper according to the labels on the feed Trays (1, 2, 3, 4, 5 with 1 being on top) with the tabs on the trail edge. If the job uses hole-
punched tabs and hole-punched body stock, make sure both stocks are loaded in the tray with the hole-punched edge leading. Use only
forward collated tabs.
2. Program media for the feed trays and run job 1-N, face-down.
3. The system assumes tabs are right-edge portrait or bottom-edge landscape. If the job is different, you may need to select [rotate 180] for the
entire job.
4. From the FreeFlow Print Server user interface, select [Printer: Media Optimization]. The window containing Media Optimization Switches
displays.
5. Select [Pre-Cut Tabs] and [OK]. You are now running in Pre-Cut Tab mode and the job will print up to 240 ipm, regardless of whether or not
the job contains tabs.
6. When you finish running jobs that include cut tabs, make sure you disable Pre-Cut Tab mode by first selecting [Printer: Media Optimization]
and then [Normal] from the Media Optimization Switches dialog.
Document. For information on printing with preprinted tabs on a Multifunction Finisher Pro Plus,
CAUTION!
or if the tabbed stock is smaller than 8.5 inches (215.9mm).
128 of 256
Advertisement
