Advertisement
Running System Diagnostics
file:///C|/Documents%20and%20Settings/Miz%20B/My%2.../Nuvera%209.0%20UGTA_FINAL/English/mnt_diag_00.htm (3 of 3)8/13/2008 2:29:06 PM
Recovery Offset Enabled - If selected, on systems equipped with either an MFF or BFM only, the first recovered
sheet delivered to the finisher following a jam will be offset from the rest of the unfinished set (this applies to
unfinished sets only and not stapled sets). It is intended to help the operator examine the set for completeness
following a jam. Only the first sheet after recovery is offset.
Enable Tab Leading Sheets in IOT - not available to the user. This feature is accessible by a trained customer
operator or a Xerox technical representative only. It should always be selected to ensure that jobs containing
precut tabs are oriented correctly in Tabs Optimization Mode and will run optimally with the print rate maximized.
This feature should only be deselected if Print Engine A2 is unable to process precut tabs without damaging them.
System: Advanced User Diagnostics
If the Xerox Productivity Plus (XPP) service option is enabled, this diagnostic mode is intended for and accessed by a
trained customer operator only. The trained operator logs onto and accesses these advanced diagnostics to perform
certain repair and maintenance procedures without the need to contact Service. For more information, refer to your XPP
documentation or contact a Xerox sales representative.
MFF B (not applicable to the Xerox Nuvera 288 Perfecting System)
dC1255 Booklet Staple Position Setup - used to align the staples on a folded booklet
dC1254 Booklet Crease Position Setup - used to align the folded edge on a folded booklet
236 of 256
Advertisement
