Advertisement
|
Home
file:///C|/Documents%20and%20Settings/Miz%20B/My%20D...20UGTA/Nuvera%209.0%20UGTA_FINAL/English/mnt_040.htm8/13/2008 2:28:52 PM
|
Resources
System Tour
Restarting the System
If your machine performance becomes degraded, or it ceases to function correctly for any reason, executing a Restart will usually
restore correct function. If the problem continues, contact your Xerox representative.
NOTE: If the system is restarted during the printing of a very long job, the system may take a long time to recover the job -
approximately 1 minute for each 10,000 pages in the job.
To restart the system
There are two ways to restart the Xerox Nuvera:
Method A Restart: a shutdown and restart of the FreeFlow Print Server software.
Method B Shutdown : a machine shutdown.
TIP: If system performance becomes degraded, try Method A first. If this solves performance problems, don't perform Method
B. If system performance is still poor, perform Method B.
Method A: Restart the system
1. In the user interface, click [System: Restart].
2. In a few moments, the system will begin an orderly shutdown of services.
3. The system will then begin an orderly startup. Wait several minutes for the system to load all services before clicking
anywhere in the user interface.
Method B: Shut down the system
1. In the user interface, click [System: Shutdown].
2. Click [Yes] to shut down the system in an orderly fashion, after all scheduled jobs are processed.
3. Click[ Interrupt] to shut down the system without completing the processing of current jobs.
4. Click [No] to return to the user interface.
5. In a few moments, the system will begin an orderly shutdown.
6. Once the system has completely shutdown, wait 30 seconds and power on the system by pressing (I) on the power switch
located on the lower right corner of the control console.
For details on powering on the system, see
|
Search
|
Problem Solving
Powering On the Xerox
Nuvera.
211 of 256
|
Index
About this Site
|
Maintenance
Advertisement
