Advertisement
|
Home
How Do I?
file:///C|/Documents%20and%20Settings/Miz%20B/My%2...TA/Nuvera%209.0%20UGTA_FINAL/English/hdi_f_030.htm (1 of 2)8/13/2008 2:14:01 PM
|
Resources
|
System Tour
Delivering Document Sets to the Stacker
Printing out large volumes of documents is not a problem for the Xerox Nuvera. On the other hand, sorting and delivering those
documents to people is difficult and time consuming if the output is not organized.
For more information about document set sorting at the Xerox Nuvera, see
Multifunction Finisher (MFF)
The other use for the Bottom Tray on the MFF is for
NOTE: The MFF is the basic or standard finisher on Xerox Nuvera. It is not available with any other finishers and the Sheet
Enhancement Module is not part of the configuration.
Basic Finishing Module (BFM)
The BFM includes a top tray, which serves as a purge tray and as a destination for stocks ineligible for delivery to the stacker (refer to
the CED for stock compatible with the system). It also includes a high-capacity stacker. The BFM Plus has a bypass paper path in
place of the top tray.
For details, see
Basic Finishing Module
the Basic Finishing Module
(BFM).
NOTE: For the BFM paper backed transparencies can go to the stacker. All other transparencies types must go to the top tray.
To send document sets to the stacker
Documents submitted from a client application can be programmed to use the stacker. See
1. At the Xerox Nuvera user interface, initiate a job and make job programming choices.
2. On the Output tab, choose the Stapling/Finishing button.
3. Click on the Output Location pull-down menu, and choose Finisher.
NOTE: This set of steps applies to systems with either an MFF or BFM.
4. To aid in the sorting and distribution of your output, you may want to program offset into the documents going to the stacker.
For details, see
Using Offset to Separate Documents in a
NOTE: Jobs with different sized papers can be stacked in the main tray. Small papers should be stacked on top of large papers
to prevent the stack from falling over.
To unload the BFM stacker
When the job assigned to the BFM stacker prints, the BFM collects the sheets in the stacker bin. Once the bin limit is reached, the BFM
drops the sets onto the stack below.
After the print job finishes, the system will unload the stacker based on the stacker limit setting. For information on how to select the
stacker limit, refer to
Using the Basic Finishing Module
1. Select the Unload button on the UI or press the Unload button on the front of the BFM.
2. When the LED is blinking, open the tray access door.
3. Grasp the black handle and slide tray outward.
|
Search
|
Problem Solving
making
booklets, dual-stitched, saddle-stitched, and folded documents.
Specifications. For information on using the Variable Shaped Tray on the BFM, refer to
Stack.
(BFM).
CAUTION!
Do NOT open the BFM front door and the stapler door at the same time.
43 of 256
|
Index
About this Site
|
Maintenance
Using
Offset.
Printing from your
PC.
Using
Advertisement
