Advertisement
|
Home
file:///C|/Documents%20and%20Settings/Miz%20B/My%20D...0UGTA/Nuvera%209.0%20UGTA_FINAL/English/psg_iq10.htm8/13/2008 2:37:15 PM
|
Resources
System Tour
Removing Moiré Patterns from
Images (when scanning or copying)
The following excerpt is taken from Real World Scanning and
Halftones by Glenn Fleishman, David Blatner, and Steve Roth:
"Moiré ("mwah-RAY") patterns are caused by our eyes'
perception of straight lines and repeating patterns. Anytime you
overlay a bunch of straight lines or grids on top of each other,
you have the opportunity for moiré patterns. One grid, all by its
lonesome, never has a problem with these patterns. It's when
you have two or more overlaid on each other that the wires in
your perceptual system get crossed, and these little gremlins
start to appear."
Moiré patterns occur when scanning copying an original that is
comprised of a halftone. Moiré is a form of digital artifact that
occurs when two regular patterns intersect to form a new
pattern. Because the new pattern is always more coarse that
the two original patterns, the appearance will change as a
function of screen frequency and angle. Typically, the finer of
the two originals patterns are the easier it is to see the Moiré.
Lower frequency halftone screens are less prone to visible
Moiré.
Moiré can occur while viewing scanned halftones on a monitor
screen, because the monitor has a certain screen frequency,
which may or may not be in alignment with the screen frequency
and angle of the original image.
Suggestions for removing moiré patterns:
From Copy or Scan Services, select the Image quality
tab.
If your image contains a halftone, make sure you are
NOT using Text Mode. If legibility of the the text is
important, and good reproduction of any pictures is
also needed, consider using Mixed Text & Halftones
as the original type.
Decrease the Sharpen control slightly. See
Sharpness.
Rotate the original slightly on the Document Glass.
Scan/Copy at the highest possible resolution capable
by the system.
Wherever possible, scan/copy continuous tone images
(for example, photographs) only. If there is no
continuous tone original available, scan/copy the
halftoned image as a last resort.
When submitting a print job, you may need to select a
different halftone.
TIP: If you have programmed and run a job, and
received unexpected results, ensure that the system-
wide settings are all set back to their defaults by clicking
<Clear All> or <Reset> in the user interface. Then
proceed to do job programming pertinent to your job.
|
Search
|
Problem Solving
Examples
Figure 1:
Figure 1: Result of two distinct patterns superimposed
Figure 2:
Figure 2: Patterns with distinct screen angle and LPI frequency
superimposed to form moiré pattern.
Adjusting
246 of 256
|
Index
About this Site
|
Maintenance
Advertisement
