Advertisement
|
Home
How Do I?
file:///C|/Documents%20and%20Settings/Miz%20B/My%20D...%20UGTA/Nuvera%209.0%20UGTA_FINAL/English/cru_50.htm8/13/2008 2:08:38 PM
|
Resources
|
System Tour
Replacing the Hole Punch Waste
Container
When the Hole Punch Waste container in the Interface Module
of the Multifunction Finisher Pro Plus reaches its limit, an alert
will appear in the system messages portion of the user interface
screen.
NOTE:A 90% full warning appears before the waste
container is completely full. This gives you the
opportunity to finish any jobs in progress. As soon as
the job is printed, replace the waste container. If a full
warning appears, the system will no longer punch jobs
in progress until the waste container is emptied and
replaced.
To replace the Hole Punch Waste Container
Make sure there are no jobs running.
1. Open the front access cover of the MFF Insertion
Module and locate the black waste container.
2. Remove the waste container by grasping the black
handle and sliding it straight out.
3. Empty the waste container.
4. Insert the empty waste container. Align the small black
knobs on either side of the container on top of the
metal brackets.
5. Push the container in all the way until it stops, making
sure it is completely seated.
6. Close the access cover of the MFF.
|
Search
|
Problem Solving
225 of 256
|
Index
About this Site
|
Maintenance
Advertisement
