Advertisement
|
Home
How Do I?
file:///C|/Documents%20and%20Settings/Miz%20B/My%20Documents/A_Xerox...P/Nuvera%209.0%20UGTA/Nuvera%209.0%20UGTA_FINAL/English/comp_070.htm (1 of 5)8/13/2008 1:45:49 PM
|
Resources
|
System Tour
Printing/Copying on Tabbed and Ordered Stock
Because of the special procedures required to use tabs, take time to review this section before attempting to use tabs with the Xerox Nuvera.
NOTE: For information on loading tabbed stock in the Sheet Feed Module, see
Guide installed in the feed tray that contains the tabbed stock.
NOTE: Pre-cut tabs can only print 1-sided. Full-cut tabs can print on both sides, either simplex or duplex.
To print or copy on tabbed stock
For systems with a Multifunction Finisher (MFF)
Use only reverse collated tabs.
Load paper according to the labels on the feed trays (5, 4, 3, 2, 1 with 5 being on top) with tabs on the trail edge.
Program feed trays.
Run job N-1, face-up.
If printing on 8.5x11" tabs, set the properties for the tabs as single-sided Exception Pages and set image shift to 1/2".
If using preprinted tabs, add as Inserts.
If the job uses hole-punched tabs and hole-punched body stock, make sure the both stocks are loaded in the tray with the hole-punched
edge leading.
The system assumes tabs are right-edge portrait or bottom-edge landscape. If the job is different you may need to select [rotate 180] for the
entire job.
If using Build Job to program the tabs job, select Build Job Type: Contains Tab Stock or Envelopes.
Tabs cannot be loaded in the Insertion Module.
For systems with a FTM/DS5000 or BFM type finishers
Use only forward collated tabs.
Load paper according to the labels on the feed trays ( 1, 2, 3, 4, 5 with 1 being on top) with tabs on the trail edge.
Program media for feed trays.
Run job 1-N, face-down.
|
Search
Index
|
Problem Solving
127 of 256
|
About this Site
|
Maintenance
Using the Feed Module Tab
Guides. You must have the Tabs
Advertisement
