Advertisement
Setting up a Print Job
file:///C|/Documents%20and%20Settings/Miz%20B/My%2...TA/Nuvera%209.0%20UGTA_FINAL/English/hdi_p_010.htm (3 of 3)8/13/2008 2:19:34 PM
To print and finish a job that contains the PCL job separator command (&l1T), send the job to a queue that does
DS5000
not have an override set for finishing. A default value is okay - just make sure there is no override.
PCL job with job
Setting an override for Finishing results in all job level finishing options being ignored and the default finishing
separator command
option being applied to the full job. The PCL job separation command falls into finishing category.
MFF Pro and Pro
Plus
You do not need to press the Finisher Unload Button to remove output from the finisher. When you press the
Finisher Unload
Finisher Unload Button, the finisher cycles down. Press the Finisher Unload Button again to re-enable marking.
Button
If landscape C-fold or Z-fold jobs printed from print clients, or the SDDF LEF scan, are rotated 180 degrees, select
C or Z fold jobs
180 degree rotation from the Advanced tab in Print Drivers at the PC application or from the Image Edit tab, Image
rotated 180 degrees
Rotation, at the Copier/Printer user interface.
PostScript Jog
command
The PostScript Jog command, when used within a job, does not perform as described in the Adobe PostScript
specifications. Changes to the Jog value create subsets to which the job or queue level finishing selections are
applied. For example, if a job specifies<</Jog 3>> setpagedevice on page 1 and <</Jog 0>>setpagedevice on
page 5, then pages 1 through 4 will be finished as a unit and pages 5 through the end of the job will be finished as
a separate unit. This is the same behavior as other Xerox production printers, such as the DocuTech 6180.
On a MFF system, if you are Dual stapling mixed sizes (that are a mix of LEF and SEF) from the Copy pathway,
they will print and staple correctly. However, if you also save the job and reprint it later, the job will Fault. The Print
Dual Stapling with
pathway currently can not handle Dual stapling with mixed sizes.
Mixed Sizes
See also:
For an overview of more sophisticated jobs and workflows, see
For details about advanced features, see
Setup Complex
Use Advanced
Features.
75 of 256
Jobs.
Advertisement
