Advertisement
Basic Finishing Module (BFM) Specifications
file:///C|/Documents%20and%20Settings/Miz%20B/My%...GTA/Nuvera%209.0%20UGTA_FINAL/English/spec_41.htm (2 of 4)8/13/2008 4:44:25 PM
250 sheets of 20 lb bond (76 gsm) or equivalent
Output to the Top Tray is delivered with Side-1 down and sets are not
offset. It can be set as a destination tray for non-stapled jobs. Sheets less
Top Tray Capacity
than 7 inches in the process direction or 8 inches in the cross-process
direction will automatically go to the Top Tray. The Top Tray also
receives sheets that are purged from the system.
3000 sheets of 20 lb bond (76 gsm) or equivalent
The stack limit can be set from the UI for each BFM independently.
Stapled sets with <15 sheets are limited to 100 sets.
Stacker Capacity
The Stacker is the output tray for receiving compiled stapled and
unstapled sets as well as single sheets. Output is normally delivered with
side-1 down and sets can be offset.
Up to 100 sheets of 20 lb bond (75 gsm) (one or two staples) or
equivalent substrates (reduced stapled sheet capabilities can result
based on substrate properties (i. e. thickness, density, material, coating,
etc.)
Includes two internal pass-through 100 sheet upside down staplers. The
stapler devices have the ability to portrait, landscape or dual staple all
supported paper sizes. Finished sets can be stacked internally to the
lower stacker tray.
Stapler Capacity
If either of the Staplers runs out of staples see
jams see
An alternate Staple Cartridge for up to 30 sheets of 20lb is available. (75-
80 gsm) paper capacity.
Each Stapler Cartridge holds 5000 staples.
on ordering refills.
Paper Size Range
process direction
8.26 in to 18.5 in (210 mm to 457 mm)
cross process direction
8.26 in to 12 in (210 mm to 305 mm)
Stock Weight Range
uncoated:
16 lb bond to 113 lb index (56 to 250 gsm)
coated:
90 to 250 gsm
NOTE: For information on how to use the BFM and BFM Plus and send documents to the stacker, see
Finishing Module
and
Delivering Document Sets to the
Configurations
There are a number of possible 'Finishing' combinations for installing the BFM, Insertion Module, Finishing Transport Module (FTM)
and other external finishers on a Xerox Nuvera system. The BFM and BFM Plus or BFM Plus and BFM Plus can be installed together
to double the stacker capacity.
The diagrams below highlight some of the more common finishing configuration options. Notice that the Xerox Nuvera 288 Perfecting
System includes two print engines in its configuration. Only the Nuvera EA Production System with a MFF does not include a Sheet
Enhancement Module, which is always located directly after the print engine (or second print engine on the 288 system).
Print Engine / SEM/ BFM
Print Engine / SEM/ Insertion Module / BFM
BFM
Clearing Staple
Jams.
Contact Xerox
for information on ordering refills.
Contact Xerox
Stacker.
179 of 256
BFM Plus
Only available on the
Bypass BFM Top
Tray with Direct
Connect
Same
Same
Replacing Staples
or if it
for information
Same
Same
Using the Basic
Advertisement
