Advertisement
Using the Basic Finishing Module (BFM)
file:///C|/Documents%20and%20Settings/Miz%20B/My%...uvera%209.0%20UGTA_FINAL/English/hdi_f_BFM_00.htm (3 of 3)8/13/2008 2:17:03 PM
5. Close the Elevator Tray.
Related Hints and Tips
Tab behaviors for non-MFF systems only
On non-MFF systems, tab jobs are delivered to the finisher face down in 1 to N order. As such, the following must be noted:
Tabs must be loaded in the feeder tray in 1 to N order (commonly referred to as forward-ordered tabs)
There are no special loading instructions required for drilled or pre-printed stock. Load those stocks according to the labels on
the feeder trays.
NOTE: If the labels indicate that drilled paper is to be loaded with the holes along the trailing edge (to the right), then
the incorrect labels are installed on the feeder module. Contact service for a replacement.
Explore the links below to learn all of the ways to utilize the BFM.
Delivering Document Sets to a Stacker
Using Offset to Organize Documents in a Stack
Replacing Staple Cartridges
Clearing Staple Jams
Clearing Paper Jams
Unloading the Stacker
53 of 256
Advertisement
