Advertisement
|
Home
file:///C|/Documents%20and%20Settings/Miz%20B/My%20Do...Nuvera%209.0%20UGTA_FINAL/English/comp_IPoser_000.htm8/13/2008 1:45:40 PM
|
Resources
System Tour
Adding Pages to your Document with the SFM Insertion Module
The SFM Insertion Module is either a 2-Tray or 4-Tray Sheet Feed Module used as a post-process inserter (pages do not go through
the print engine). Use the SFM Insertion Module to add covers, inserts, or slip sheets to your documents. The SFM Insertion Module fits
between the print engine (or, if applicable to your configuration, the Sheet Enhancement Module) and the finishing device.
NOTE: To learn how to insert covers, preprinted tabs or colored paper into your job using the Insertion Module on the
Multifunction Finisher (MFF) Pro Plus, refer to
The addition of the SFM Insertion Module does not affect production speeds since covers and inserts are merged into the paper path
after marking takes place, without requiring a gap in the pitch. For more information, see a description of pitch.
To Add Sheets with the SFM Insertion Module
Pick a stock that is loaded in the SFM Insertion Module, and program that on a blank insert sheet or cover (through the Special Pages
dialog).
The system should feed blank sheets from the SFM Insertion Module whenever possible.
NOTE: Page insertion with the SFM Insertion Module may not occur when there is a blank page in the actual document. The
system software does not detect blank pages embedded in documents, and will not trigger page insertion.
Alternatively, both of the SFM Insertion Module feed bins can be loaded with the same stock, allowing continuous uninterrupted
production insertion of pre-printed stocks and the addition of photographs and other sensitive documents that normally could be
damaged by heat from the fuser section of the printer.
|
Search
|
Problem Solving
Using the Multifunction Finisher Pro
135 of 256
|
Index
About this Site
|
Maintenance
Plus.
Advertisement
