Advertisement
|
Home
How Do I?
file:///C|/Documents%20and%20Settings/Miz%20B/My%20D...%20UGTA/Nuvera%209.0%20UGTA_FINAL/English/cru_60.htm8/13/2008 2:08:36 PM
|
Resources
|
System Tour
Replacing the Hole Paper Punch
There are two types of Hole Punch modules that can be used
with the Multifunction Finisher Pro Plus:
2 and 3 Hole Paper Punch, or
2 and 4 Hole Paper Punch
If the 2/3 Hole Paper Punch is installed, you can indicate that
you want to finish and punch your printed documents with 2 or 3
holes at the lead edge. If the 2/4 Hole Paper Punch is installed,
you can identify your documents to be finished and punched
with 2 or 4 holes. The various punch finishing options, such as
hole punching Portrait Top or Landscape Right, are selectable
from the Output tab, the Stapling/Finishing area on the
FreeFlow Print Server interface. Use this hole punching feature
if you want to easily place your finished document in a 2, 3 or 4
ring binder.
The Hole Punch module is first installed and set up on the
system by a Xerox CSE. If you would like to switch to using the
other type of hole punch at any time, you must contact your
Xerox representative who can order the 2/3 or 2/4 Hole Punch
module. Once ordered and the CSE has completed running the
NVM setup routine for the new hole punch module, you can
then install and replace your current hole punch (for instance,
2/3) with the other hole punch (2/4).
To Replace the Hole Paper Punch
See
Contacting Xerox
to get the correct part order number for
this unit.
Make sure there are no jobs running. Also, you can refer to the
label on the inside of the MFF Insertion Module cover door for
removal instructions.
1. Open the front access cover of the MFF Insertion
Module and locate the hole punch module.
2. Locate the black handle with the orange strip.
3. Remove the hole punch module by lifting the handle
upwards and pulling straight out until you hear a click.
4. At the top of the hole punch module, grasp the long
upper orange handle and, holding firmly, use the
handle to slide and lift the module out.
5. Replace the new hole punch module. With the orange
strip facing you and long orange handle on top, align
the sides of the hole punch module against the MFF
channel and slide it straight into the channel.
6. Completely insert the hole punch module until you hear
a click.
7. Close the access cover of the MFF.
|
Search
|
Problem Solving
Hole Punch Module:
2/3 Hole Paper Punch or a 2/4 Hole Paper Punch
226 of 256
|
Index
About this Site
|
Maintenance
Advertisement
