Advertisement
|
Home
file:///C|/Documents%20and%20Settings/Miz%20B/My%20D...0UGTA/Nuvera%209.0%20UGTA_FINAL/English/psg_iq70.htm8/13/2008 2:37:21 PM
|
Resources
|
System Tour
Removing Spots & Specks
(when scanning or copying)
If you notice spots or specks on your image, try the following:
Clean the Document Glass
Dirt and dust in the work environment, finger prints, and paste-up residue from documents will gradually build up on the Document
Glass. Sometimes this shows up on scans as specks or spots.
Optimally, the Document Glass should be cleaned at the start of each work day.
Carefully clean the Document
Glass.
Clean the Document Feeder
Though the Document Feeder is mainly enclosed, dirt and paper dust can get into the paper path and rollers, causing spots, streaks
and specks on the output image.
Optimally, the Document Feeder should be cleaned at the start of each work day.
Carefully clean the Document
Feeder.
TIP: If you have programmed and run a job, and received unexpected results, ensure that the system-wide settings are all set
back to their defaults by clicking <Clear All> or <Reset> in the user interface. Then proceed to do job programming pertinent
to your job.
|
Search
|
Problem Solving
254 of 256
|
Index
About this Site
|
Maintenance
Advertisement
