Advertisement
Using the Finishing Transport Module (FTM)
file:///C|/Documents%20and%20Settings/Miz%20B/My%...uvera%209.0%20UGTA_FINAL/English/hdi_f_XIM_00.htm (2 of 2)8/13/2008 2:17:05 PM
Tab behaviors for non-MFF systems only
On non-MFF systems, tab jobs are delivered to the finisher face down in 1 to N order. As such, the following must be noted:
Tabs must be loaded in the feeder tray in 1 to N order (commonly referred to as forward-ordered tabs)
There are no special loading instructions required for drilled or pre-printed stock. Load those stocks according to the labels on
the feeder trays.
NOTE: If the labels indicate that drilled paper is to be loaded with the holes along the trailing edge (to the right), then
the incorrect labels are installed on the feeder module. Contact service for a replacement.
For More Information
For information about printing to the BFM, see
For information and video demonstrations on clearing paper jams in the FTM, see
For information about FTM specifications, see
For details on the specifications of the DFA-compliant 3rd Party Finishers, contact your Xerox representative for the Solutions
Planning Guide for that finisher.
Using the Basic Finishing Module
Finishing Transport Module (FTM)
55 of 256
(BFM).
Clearing Paper
Jams.
Specifications.
Advertisement
