Advertisement
Using Build Job
|
Home
How Do I?
file:///C|/Documents%20and%20Settings/Miz%20B/My%...GTA/Nuvera%209.0%20UGTA_FINAL/English/adv_020.htm (1 of 2)8/13/2008 1:33:22 PM
|
Resources
|
System Tour
Using Build Job
NOTE: This feature is only available if your system includes the integrated Document Scanner module for copying and
scanning jobs.
Build Job is used to combine multiple scans, each with different job programming, into a single, compiled output. Specifically, Build Job
allows you to scan many different types of documents (either from the Document Feeder or the Document Glass) in separate jobs, then
combine those separate scan jobs into one cohesive output.
Build Job is used to:
Scan originals of different sizes that cannot be fed and scanned together
Scan a collection of originals that require a mix of Document Feeder and Document Glass scanning
Scan more originals than the Document Feeder can hold at one time (see
Apply different image quality or image modification features to different scan segments
NOTE: Build job applies to any type of scan job and does NOT apply to print jobs.
Before using Build Job, there are two concepts to understand. See
To use Build Job
1. In the Xerox Nuvera user interface, click Copy, then click the <Build Job> button at the bottom left corner of the user
interface. The system is now in Build Job mode.
2. Place the first part of the document set (Job Segment 1) to be scanned in the
NOTE:At this point, perform any
when scanning the remaining Job Segments.
3. Once Job Level programming is complete for Job Segment 1, press <Continue>. The remainder of the tabs become enabled.
Perform any
Segment Level
4. When satisfied with your settings, click <Start>. Job Segment 1 begins scanning.
5. When Job Segment 1 finishes, load the second part of the document set (Job Segment 2) to be scanned in the Document
Feeder or Document Glass.
6. Make any Segment Level programming. Remember,
disabled.
7. When satisfied with your settings, click <Start>. Job Segment 2 begins scanning.
8. Load the next Job Segment, and perform steps 6, 7, and 8 for the remaining segments.
9. To exit Build Job mode, click <End Build Job>. The job prints according to all of the Segment and Job Level programming.
|
Search
|
Problem Solving
Understanding Job and Segment Level
Job Level
programming, since Job Level programming choices will be unavailable
programming.
Job Level programming
104 of 256
|
Index
About this Site
|
Maintenance
Scanner
Specifications)
Programming.
Document Feeder or Document
is already set, so all Job Level controls will be
Glass.
Advertisement
