Advertisement
|
Home
How Do I?
file:///C|/Documents%20and%20Settings/Miz%20B/My%20Do...A/Nuvera%209.0%20UGTA_FINAL/English/spec_paper_50.htm8/13/2008 5:01:09 PM
|
Resources
|
System Tour
Paper and Tray Performance Matrix -- Loading Special Stock
The Xerox Nuvera can process a wide array of stock types. Use the following topics to learn how each stock type can be expected to
perform in the system
Stock Type
Common Uses
Hole-Punched
Ringed binders
Coated (not
Presentations, collaterals
supported on MFF)
Pages for partial removal,
Perforated
such as order forms and
receipts
Common
Pre-printed and
correspondence, mailings
letterhead
and advertising materials
Reinforced Mylar edge Ring binders
Card stock
Covers, signs
Transparencies
Presentations
Self-adhesive labels for
Labels
envelopes and packaging
|
Search
|
Problem Solving
Recommendation
Use long edge feed for best copy speed (load with holes to the right).
When printing on coated stock that has only one side coated, load the
coated side UP.
Where possible, load with perforation parallel to the feed direction.
Use ultra-violet cured or oxidative inks to extend the life of the
feed roll cartridges.
Load face-up in Trays 1 - 4.
Load reinforced edge on the right in Trays 1 - 4.
Use long-edge feed only.
For best results, set Heavy Weight attribute when programming Trays 1 - 4.
NOTE: The paper path/sensors in the Xerox Nuvera do not require
that you feed transparencies with removable stripes. If you have
this type of media, you can use it, but the stripe is not necessary
for proper function.
NOTE: For dedicated transparency trays, first place approximately
half an inch (12 mm) worth of plain paper at the bottom of the tray.
This will ensure that all 50 of the transparencies get used.
For all transparencies, refer to the label on the tray for correct
orientation.
When using transparencies with removable stripes, load with the
stripe down in Tray 1 - 4.
Do not program 2-sided.
For best results, set Heavy Weight attribute when programming
Trays 1 - 4.
Nuvera supports only 8 1/2 x 11" (A4) transparencies.
Do not program 2-sided.
For best results, feed labels into the machine LEF only.
Load face-up in Trays 1 - 4.
For best results, set Heavy Weight attribute when programming
Trays 1 - 4.
201 of 256
|
Index
About this Site
|
Maintenance
Note
Advertisement
