Status Leds; User I/O - Xilinx VC707 User Manual

Chapter 1: VC707 Evaluation Board Features

Status LEDs

[Figure
Table 1-25
Table 1-25: Status LEDs
Reference
Designator
DS11 PHY_LED_RX
DS11 PHY_LED_LINK1000
DS12 PHY_LED_TX
DS12 PHY_LED_LINK100
DS13 PHY_LED_DUPLEX
DS13 PHY_LED_LINK10
DS14 PWRCTL1_VCC4A_PG
DS10 FPGA_DONE
DS1 FPGA_INIT_B
DS16 VCC12_P_IN
DS17 PWRCTL_PWRGOOD
DS18 LINEAR_POWER_GOOD

User I/O

[Figure
The VC707 board provides the following user and general purpose I/O capabilities:
•
•
•
•
•
•
50
Send Feedback
1-2, callout 21]
defines the status LEDs. For user controlled LEDs see
Signal Name
GREEN/RED
1-2, callout 22 - 26]
Eight user LEDs (callout 22)
• GPIO_LED_[7-0]: DS9, DS8, DS7, DS6, DS5, DS4, DS3, DS2
Reset switch and five user pushbuttons (callout 23)
• CPU_RESET: SW8
• GPIO_SW_[NESWC]: SW3, SW4, SW5, SW7, SW6
8-position user DIP Switch (callout 24)
• GPIO_DIP_SW[7-0]: SW2
User rotary switch (callout 25, hidden beneath the LCD)
• ROTARY_PUSH, ROTARY_INCA, ROTARY_INCB: SW10
User SMA (callout 26)
• USER_SMA_GPIO_P, USER_SMA_GPIO_N: J33, J34
2 line x 16 character LCD character display (callout 19)
• If the display is unmounted, connector J23 pins are available as 7 independent
GPIOs. The LCD connector J23 details are shown in the
(16 x 2) section.
www.xilinx.com
Color
GREEN Ethernet PHY RX
GREEN Ethernet Link Speed is 1000 Mb/s
GREEN Ethernet PHY TX
GREEN Ethernet Link Speed is 100 Mb/s
GREEN Ethernet Link is Half-duplex
GREEN Ethernet Link Speed is 10 Mb/s
GREEN FMC1 HPC Power Good
GREEN FPGA Configured Successfully
GREEN: FPGA Initialization Successful,
RED: FPGA Initialization in Progress
GREEN 12V Power ON
UCD9248 Power Controllers (U42, U43, U64)
GREEN
Power Good
GREEN TPS51200 Power Good (U23)
User I/O.
Description
LCD Character Display
VC707 Evaluation Board
UG885 (v1.4) May 12, 2014