Xilinx VC707 User Manual page 56

Chapter 1: VC707 Evaluation Board Features
The VC707 Evaluation Kit provides the adapter cable shown in
the VC707 board from the ATX power supply 4-pin peripheral connector. The Xilinx part
number for this cable is 2600304, and is equivalent to Sourcegate Technologies part number
AZCBL-WH-1109-RA4.
X-Ref Target - Figure 1-29
Figure 1-30
X-Ref Target - Figure 1-30
FPGA_PROG_B Pushbutton SW9 (Active-Low)
[Figure
Switch SW9 grounds the FPGA's PROG_B pin when pressed. This action initiates an FPGA
reconfiguration. The FPGA_PROG_B signal is connected to FPGA U1 pin AJ11.
See 7 Series FPGAs Configuration User Guide (UG470)
configuring the 7 series FPGAs.
Figure 1-31
56
Send Feedback
To ATX 4-Pin Peripheral
Power Connector
Figure 1-29: ATX Power Supply Adapter Cable
shows the power connector J18, power switch SW12 and indicator LED DS16.
J18
VCC12_P_IN
1
12V
4
12V
2
N/C
5
N/C
3
COM
6
COM
INPUT_GND
PCIe
Power
Figure 1-30: Power On/Off Switch SW15
1-2, callout 28]
shows SW9.
www.xilinx.com
SW12 U73
1
2
3 1
4
5
6
C471
1μF
25V
3
INPUT_GND
[Ref 2]
Figure 1-29 for powering
To J18 on VC707 Board
UG885_c1_26_030512
VCC12_P
8
C320 R279
330μF 1kΩ
1%
25V
7
DS16
6
5
GND GND
UG885_c1_27_030512
for further details on
VC707 Evaluation Board
UG885 (v1.4) May 12, 2014