Four-Wheel Drive (4Wd) Control Switch (If Equipped) - New Holland B95C Original Instructions Manual

Four-Wheel Drive (4WD) control switch (if equipped)

Machines with or without four wheel drive should not be
allowed to exceed 40 km/h (24.8 mph)
WARNING
Loss of control hazard!
Machines with four-wheel drive engaged or
disengaged should not exceed 50 km/h (31
mph) where permitted.
towing or coasting downhill with clutch de-
pressed or transmission in neutral may cause
loss of control, personal injury to the operator
or bystanders, or mechanical failure.
Failure to comply could result in death or se-
rious injury.
4WD switch (1)
This switch has two positions:
• Left position (power shuttle):
• Rear wheel drive and braking on rear wheels for all
gears (lamp off).
• Left position (powershift):
• Rear wheel drive with braking only on rear wheels
(only in first and second gear) (lamp off); four wheel
drive and braking (in third and fourth gear) (lamp on).
• Right position:
• 4 wheel drive and braking on 4 wheels (lamp on).
NOTE: To prevent undue tire wear when travelling on pub-
lic highways or on any hard surface, it is recommended
that the four wheel drive is disengaged, particularly in 3
th
or 4 gear.
NOTICE: 4WD braking is only active with both brake ped-
als latched together.
4 - OPERATING INSTRUCTIONS
Over speeding by
W0454A
rd
4-22
1
LEEN11T0122AA