Powershift transmission - Oil filter replacement
1. Move the machine to a level and firm surface.
2. Raise the loader attachment and install the safety sup-
port strut.
3. Place the backhoe attachment in the road travel posi-
tion.
4. Place the direction-of-travel lever and gearshift lever in
the neutral position.
5. Engage the parking brake.
6. Stop the engine and remove the starter switch key.
7. Release any possible residual pressure from the hy-
draulic system by moving the control levers in all direc-
tions.
8. Unlock, open and raise the engine hood.
9. Clean the area around the oil filter and filter head (1).
10. Place a container with suitable capacity under the filter
(1).
11. Loosen and remove the filter.
12. Apply a thin layer of oil on the new filter seal.
13. Install the new oil filter (1).
14. Tighten the new filter by hand until the seal touches
the filter head.
15. Tighten the filter by hand an additional 2/3 of a turn.
NOTICE: Overtightening can damage the filter seal.
16. Start the engine and run the machine with the parking
brake engaged and the direction-of-travel lever and
gearshift lever in the neutral position.
17. Remove the dipstick (2).
18. Check the oil level, and add additional H
T
O
RANSMISSION
IL
19. Lower and lock the engine hood.
20. Remove the safety support strut and lower the loader
attachment.
Oil specification and capacities
Use H
T
YDRAULIC
RANSMISSION
Capacities: 4WD Total System 18.0 L (19.0 US qt), Re-
fill with or without filter change 11.4 L (12.0 US qt).
- P
as necessary.
REMIUM
O
- P
IL
REMIUM
7 - MAINTENANCE
YDRAULIC
.
7-107
1
LEEN11T0407AA_4
2
LEEN11T0356AA