Bulbs
NOTICE: Never touch a halogen bulb with your fingers.
Always use a clean cloth when handling halogen bulbs.
Operator's compartment light
1. Remove the lens (1) unscrewing it by turning 90°
through its central slot.
2. Remove the bulb (2) and install a new bulb.
3. Reinstall the lens (1).
Bulb wattage: 10 W
Switch lighting
1. Remove and disconnect the switch concerned.
2. Remove the bulb holder (1). Remove the bulb and
install a new bulb.
3. Install the bulb holder and the switch.
Bulb wattage: 1.2 W
Beams and turn signals
1. Remove the four screws and remove the light assembly
(1).
2. Disconnect the socket from the bulb holder connector.
Fold back the clips, remove the defective bulb and re-
place it with a bulb of the same wattage.
3. Remove out the bulb holder on the outside of the re-
flector to replace the direction indicator bulb.
NOTE: To access the direction indicator bulb, remove the
beam cover fastening screw.
NOTE: The beam can be adjusted vertically and sideways
by adjusting the slotted screws.
7 - MAINTENANCE
7-135
1
LEEN12T0488AA
2
LEEN12T0704AA
3
LEEN12T0705AA