Hydraulic System - Release Pressure - New Holland B95C Original Instructions Manual

Hydraulic system - Release pressure

1. Park the machine on firm level ground.
2. Put all transmission controls in the Neutral position.
3. Engage the parking brake.
4. Lower the bucket to the ground but do not apply down
pressure; or raise the loader arm and engage the
loader arm safety support.
5. Rotate the operator seat into the backhoe operation
position.
6. Place the backhoe in the stowed position with swing
lock pin in the lock position. If applicable, insert the Ex-
tendahoe lock pin. You may choose to rest the backhoe
attachment on the ground.
7. Shut off the engine.
8. Turn the key switch to the ON position but DO NOT
start the engine.
9. Press the emblem end of the backhoe and stabilizer
control switch to activate all backhoe controls.
NOTE: When turning the backhoe and stabilizer control switch to the ON position, wait approximately half a second
before activating the stabilizers, extendahoe (if equipped) or bi-directional auxiliary hydraulics (if equipped). If an
operator attempts to operate the functions before the delay passes, the functions will not operate. Cycle the power
switch and wait for the delay to pass.
10. If equipped with combo auxiliaries, enable the bidirec-
tional switch on the right-hand side panel.
11. Cycle the bi-directional proportional control buttons on
the left-hand pilot control joystick.
12. Move each pilot backhoe control joystick in one com-
plete circle, stopping in the neutral (center) position.
13. Deactivate the backhoe and stabilizer control switch.
14. Rotate the operator seat into the driving position.
7 - MAINTENANCE
7-132
1
LEEN12T0640AA
2
LEEN12T0487AA