Front axle system - Check — (2WD)
1. Move the machine to a level and firm surface.
2. Lower the loader attachment to the ground.
3. Place the backhoe attachment in the road travel posi-
tion.
4. Place the direction-of-travel lever and gearshift lever in
the neutral position.
5. Engage the parking brake.
Reduction gear oil level
1. Raise the front part of the machine with the loader at-
tachment until the front wheels are no longer in contact
with the ground, and place a suitable support under the
front axle.
2. Stop the engine and remove the starter switch key.
3. Manually position the wheel until the hole of the plug
(1) is in horizontal position.
4. Remove the plug (1).
5. Check the level by checking if the oil reaches the height
of the plug hole.
6. If necessary, add additional oil.
7. Insert and tighten the plug (1).
8. Repeat the operations for the other reduction gear on
the other side of the machine.
9. Remove the supports from under the font axle and
lower the machine to the ground.
Oil specification and capacities
Use P
T
REMIUM
RANSAXLE
an oil meeting the below standard: SAE 80W-140.
Capacity (each): 0.8 L (0.8 US qt)
7 - MAINTENANCE
O
80W-140 ( MAT 3510) or
IL
7-67
1
RAIL15TLB0030AA