Auto-Glide Ride™ (Agr) - Four-Wheel Drive (4Wd) Only - New Holland B95C Original Instructions Manual

Auto-Glide Ride™ (AGR) – Four-Wheel Drive (4WD) only
WARNING
Unexpected machine movement!
Stand clear of the loader arms. If you enable Glide Ride™ or Auto-Glide Ride™ control with the key
switch in the ON or ACC position, the loader arms can drop slightly due to the hydraulic accumulator.
Failure to comply could result in death or serious injury.
WARNING
Unexpected machine movement!
Stand clear of the machine. If you activate the Glide Ride™ or Auto-Glide Ride™ control while the
loader arm applies down force, the machine or load may lower unexpectedly. For example, do not
activate these controls while the loader arm supports or lifts the machine front end off the ground.
Failure to comply could result in death or serious injury.
Auto-Glide Ride™ is an optional feature on machines with Four-Wheel Drive (4WD). When Auto-Glide Ride™ (AGR)
is active, the loader down pressure is limited to the weight of the loader and the attachment (bucket). The weight of
the loader attachment is hydraulically cushioned during transport.
NOTE: Auto-Glide Ride™ should not be used for fine grading with the loader bucket, during backhoe operation or
when precise placement of the loader is required.
NOTE: AGR speed settings can be adjusted to suit the operator's preference. See "Auto-Glide Ride™ (AGR) speed
thresholds" 6-11 for details.
Before activating Auto-Glide Ride™ perform the following actions:
• Face operator seat in the forward driving position.
• Place the hand throttle control at low idle.
• Only use the foot throttle.
• Down force is not being applied with the loader.
Auto-Glide Ride™ (AGR) operation:
1. Place the rocker switch in the center position. In the
automatic position, the emblem will illuminate green in-
dicating Auto-Glide Ride™ is functioning anytime the
machine is traveling above the default speed thresh-
old 9.5 km/h (5.9 mph).
2. Disable Auto-Glide Ride™, press the blank side of
the rocker switch. The emblem no longer illuminates.
Operator's may choose to leave Auto-Glide Ride™ in the
AUTO (center) position. The selection will hold even when
power to the machine has been cycled OFF and ON.
Manual operation of Auto-Glide Ride™:
1. Lower the loader bucket to or near the ground line.
2. Press the emblem end of the rocker switch to turn ON
Auto-Glide Ride™. The emblem illuminates.
3. Disable the manual operation of Auto-Glide Ride™,
press the blank side of the rocker switch. The emblem
no longer illuminates.
4 - OPERATING INSTRUCTIONS
4-25
W1458C
W1459B
1
LEEN11T0079AA