Every 250 hours
Drive shaft lubrication
Cardan shafts - Greasing
1. Move the machine to a level and firm surface.
2. Lower the loader attachment to the ground.
3. Place the backhoe attachment in the road travel posi-
tion.
4. Place the direction-of-travel lever and gearshift lever in
the neutral position.
5. Engage the park brake.
6. Stop the engine and remove the starter switch key.
7. Release any possible residual pressure from the hy-
draulic system by moving the control levers in all direc-
tions.
8. Locate the grease fittings (1) on the cardan shafts
and apply M
-P
ULTI
PRESSURE AND ANTI
grease fittings (1): 2 (4WD) / 1 (2WD)
NOTE: Only lubricate the shaft, the U-joint does not have
a grease fitting.
M
G
URPOSE
OLY
REASE
-
NGLI-2 grease. Number of
WEAR
7 - MAINTENANCE
E
XTREME
7-59
1
LEEN11T0391AA