Drive belts - check
1. Move the machine to a level and firm surface.
2. Raise the loader attachment and install the safety sup-
port strut.
3. Place the backhoe attachment in the road travel posi-
tion.
4. Place the direction-of-travel lever and gearshift lever in
the neutral position.
5. Engage the parking brake.
6. Stop the engine and remove the starter switch key.
7. Release any possible residual pressure from the hy-
draulic system by moving the control levers in all direc-
tions.
8. Unlock, and raise the engine hood.
Air-conditioner compressor belt
1. Visually check the condition of the belt (1).
2. Replace the belt if it is worn or damaged.
3. Check the belt (1) tension and adjust if necessary. See
7-124.
Drive belt
1. Visually check the condition of the belt (1).
2. Replace the belt if it is worn or damaged. See 7-126.
3. To adjust the belt, loosen the bolts (2).
4. Tighten the screw (3) so the top bolt (2) is moved to the
end of the slot.
NOTE: This is a self adjusting belt. Further adjustment not
required.
5. Tighten the bolts (2).
7 - MAINTENANCE
7-72
1
LEEN11T0368AA
2
RAIL15TLB0041AA