Table of Contents
Advertisement
Electro-Magnetic Compatibility (EMC)
Interference may arise as a result of add‐on equipment that may not necessarily meet the required standards. As
such interference can result in serious malfunction of the unit and/or create unsafe situations, you must observe
the following:
• The maximum power of emission equipment (radio, telephones, etc.) must not exceed the limits imposed by the
national authorities of the country where you use the machine
• The electro‐magnetic field generated by the add‐on system should not exceed 24 V/m at any time and at any lo-
cation in the proximity of electronic components
• The add‐on equipment must not interfere with the functioning of the on board electronics
Failure to comply with these rules will render the NEW HOLLAND CONSTRUCTION warranty null and void.
Product identification
Record the Product Identification Numbers (PIN). If needed, give these numbers to your dealer when you need parts
or information for your machine. Keep a record of these numbers and your Manufacturer's Statement of Origin in a
safe place. If the machine is stolen, report the numbers to your local law enforcement agency.
Machine identification
Model
PIN
Locate the Product Identification Number (PIN) plate on
the right-hand side beneath the loader lift cylinder pivot
point.
NOTE: The PIN is also stamped on the right-hand side
chassis rail.
1 - GENERAL INFORMATION
1-4
1
RAIL15TLB0039AA
2
RAIL16TLB0369BA
Advertisement
Table of Contents
Troubleshooting
