Stabilizer Pads - New Holland B95C Original Instructions Manual

Stabilizer pads

WARNING
Tip-over hazard!
Put the stabilizers in the operating position before you lower the boom and extend the dipper. The
front of the machine can raise above the ground and become unstable if the stabilizers are not down
in the operating position.
Failure to comply could result in death or serious injury.
WARNING
Tip-over hazard!
Before you raise the stabilizers from the operating position, put the backhoe in the transport position
or completely retract the dipper and raise the boom. Make sure the machine tires are touching the
ground. The machine can become unstable when the tires are not on the ground.
Failure to comply could result in death or serious injury.
Always position the stabilizer pads for maximum stability. If you dig next to a building, wall etc., change the position
of the stabilizer pads.
Change the position of a stabilizer pad:
1. Remove a retaining ring from the pin on each stabilizer pad.
2. Use a hammer and drift pin and remove each pin.
3. Put the stabilizer pads into position. For correct stabilizer pad position, refer to stabilizer pad positions later in this
section.
4. Install the pins and retaining rings.
Stabilizer pad position
NOTE: Examples are shown for right stabilizers (backhoe operation position). Arrow indicates front of machine.
Standard two position stabilizer pads:
• Digging to the side (working next to buildings, walls etc.)
• Maximum stability for digging to the rear and minimum
width for traveling
6 - WORKING OPERATIONS
6-39
W0196A
W0195A
1
RCPH10TLB419AAF
2
RCPH10TLB418AAF