Preparation For Use After Storage - New Holland B95C Original Instructions Manual

Preparation for use after storage

Do not start the engine until Steps 1 through 12 have been done.
1. Change the fuel filters and fill the fuel take if required.
2. Tighten the cooling system drain valves.
3. Fill the engine cooling system.
4. Check the condition of the engine drive belt. Replace
if required.
5. Check the engine oil level.
6. Check the hydraulic oil level.
7. Check the transmission oil level.
8. Lubricate the machine at all grease fittings.
9. Use petroleum base solvent and remove the rust and
corrosion preventive from the hydraulic cylinder rods,
valve spools and any other location the preventative
was used.
10. Install a new battery or confirm the battery is charged.
11. Fill the Diesel Exhaust Fluid (DEF)/AdBlue® tank to
a minimum of 20% level.
12. If stored longer than four months, change the DEF
supply module filter as shown on 7-116.
13. Bleed the air from the fuel system. Refer to 7-128 in
this manual.
14. Start the engine. It is important that you review the
"STARTING THE UNIT" chapter on Page 4-5 in this
manual.
7 - MAINTENANCE
7-159